01/02
SHAFTSBURY SHA20
PAGE 3
TECHNICAL DATA
Model
SHA20
Colour
Black & Brass
Country of Origin
Irish Republic
Fuel Effect
Optiflame Elite (log)
Heat Source
Fan Heater
Thermostat
Bi-metal leaf
Electrical Supply
230- 240 Volts 50 Hz AC
Total Loading:
1956-2136 Watts
Elements:
1820-2000 Watts
Lamps:
2 x 60 Watts BC Lamps
Motors:
2 x 6.5 Watts, 1 x 2.5 Watts
SERVICING AND DISMANTLING INSTRUCTIONS
ENSURE APPLIANCE IS DISCONNECTED FROM THE ELECTRICITY SUPPLY BEFORE DISMANTLING.
NOTE ALL CONNECTION DETAILS AND ROUTING OF LEADS BEFORE DISMANTLING.
ALWAYS REPLACE CABLE TIES ON RE-ASSEMBLY.
Numbers appearing in the text refer to illustrations and parts list numbers.
LAMP REPLACEMENT
1.1 Grasp the grate 17 and lift it upward and away from the fire. Grasp the fuel effect and ease it out past
grate retaining screws at position "A", then lift it away.
1.2 Grip the defective lamp near its centre and rotate the lamp anti-clockwise until it comes out of its
holder. Replace the defective lamp with a 240V, 60W BC Fireglow lamp.
1.3 Reassemble, ensuring that the fuel effect sits correctly behind the grate retaining screws at position
"A", then refit the grate, engaging the hooked brackets over the two retaining screws.
MAINS CABLE
2.1 Remove the grate and fuel effect as detailed in 1.1 above, and lay the fire on its back on a soft surface.
2.2 Release the two screws securing terminal cover box "B", from underneath the chassis, and lift the box
away with light baffle "C" attached.
2.3 Disconnect the live and neutral leads from terminal block 22 and the earth screw assembly. Release
cable clamp arm 11 by squeezing the barbs from inside the chassis. Use a pair of long-nosed pliers to
squeeze the cable clamp locking tab and withdraw the clamp 11 and cable 12.
2.4 Reassemble, ensuring that wires are not trapped by the terminal cover box.
LOG FLAME EFFECT
3.1 Remove the grate and fuel effect and terminal cover box "B" as detailed in 2.1 and 2.2 above.
3.2 Detach the leads from rotisserie motor 12 to the terminal block 1. Cut cable ties where necessary to
thread the motor leads through the heat sleeving.
3.3 Release the two screws holding motor bracket "E", grasp motor coupling 13 and withdraw motor 12.
Flames rotisserie 14 is also a push fit on coupling 13 and the other end sits loosely in grommet bush
15.
3.4 To detach the motor, release the two bright screws attaching it to the motor bracket.
3.5 Reassemble in reverse order, ensuring that cable ties are replaced where necessary and that no wires
are trapped by the terminal cover box. Check that the rotisserie rotates without obstruction before
refitting the fuel effect.
