UK
Manual & Remote Operation
Setting
Operation
Setting
Flame Effect only
Press the ‘ I ’ button (Switch 3)
Top Neon
The Standby switch must first be turned ‘ON’ to operate the heater manually or
by remote control.
Note: It takes some time for the receiver to respond to the transmitter.
DO NOT PRESS the buttons more than once within two seconds for correct
operation.
To go to the previous settings press the
O
button.
Pressing the
O
button on the remote turns off the light settings.
To resume press the
I
button until the desired setting is reached - see
Fig. 8
.
To increase or decrease the brightness of the flames, use the dimmer button or
the button on the Remote Control.
To turn off the power the Standby Switch must be turned ‘OFF’.
Lamp Replacement
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
REMOVING LAMPS.
Warning -
The lamps reach high temperatures during operation. For this
reason, allow the lamps to cool down after switching off the appliance.
The front panel will need to be removed in order to change lamps – see
Fig. 9
.
Warning -
Th
e front panel is heavy and easily damaged.
On the SP29 the front panel is held at the bottom by a fixing screw.
To gain access to lamps please apply the following procedure:
Remove the fixing screw from the base of the front frame on the SP29 - see
Fig. 9.
While holding the front panel by its sides with both hands, carefully tilt the
bottom of the frame outwards until free and then lift the panel up (1) and then
away (2) from the main body - see
Fig. 9
.
To gain access to the bulbs remove the screws at ‘A’ to remove the cover
bracket ‘X’ and the screws at ‘B’ to remove the cover bracket ‘Y’ - see
Fig. 10
.
For access to the bottom bulbs, carefully slide the flexible rotisserie (see ‘a’
in
Fig. 11
) to one side ensuring that the rubber grommet is not lost (see ‘b’ in
Fig. 11
).
Remove the defective lamp by unscrewing it (see
Fig. 11
).
Replace with a 60W E14 SES Clear Candle bulb, rotating it. Take care not to
over-tighten the lamp.
Steps for reassembling the heater
1.
Refit the rotisserie making sure that the rubber grommet is carefully pushed
into the slotted hole on the axial bracket.
2.
Replace the cover brackets ‘X’ and ‘Y’ - see
Fig. 10
.
3.
Replace the front by aligning the slots on the front frame and making sure
that it catches fully on the support brackets.
4. Replace the fixing screw on the base of the front frame.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO
NOT use proprietary glass cleaners.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be
disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice in your country.
After Sales Service
Should you require after sales service or should you need to purchase any
spares, please contact the retailer from whom the appliance was purchased or
contact the service number relevant to your country on the warranty card.
Please do not return a faulty product to us in the first instance as this may
result in loss or damage and delay in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
Summary of Contents for SP29
Page 3: ...8 7 1 0 a b 9 X Y A B C 11...
Page 8: ......
