16
SYMPHONY ELECTRIC FIREPLACE
If the fireplace was operating prior to servicing allow at least 10 minutes for light
bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE HEATER ASSEMBLY
1. Remove the firebox trim by placing your hand on the grill section, grasping
the trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing
it upside down on the top of the unit being careful not to damage any of
the wiring.
5. Locate the heater assembly mounted on the top panel and disconnect the
wiring clips and connections noting their original locations.
NOTE: A small slot screwdriver is required to remove some of the heater
connections.
6. Turn the top over, remove the heater mounting screws and remove the
heater assembly by sliding it back to release mounting tabs.
7. Properly orientate the new heater assembly and connect all of the wiring
connections.
8. Reassemble in the reverse order as above.
