Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the
fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heating, so that the comforting effect may be
enjoyed at any time of the year. Using the flame effect on its own only requires little electricity.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Please note:
Used in an environment where background noise is very low, it may be possible to hear a sound which
is related to the operation of the flame effect. This is normal and should not be a cause for concern.
T
echnical Information
Model No: TLC20
with mechanic thermostat room temperature control.
Thank you for choosing a Dimplex electric fire.
General Information
Heat Output
230V
240V
Nominal Heat Output
P
Nom
1.7
1.9
kW
Minimum Heat Output
P
min
0.9
0.9
kW
Maximum Continuous Heat Output
P
max,c
1.7
1.9
kW
Auxiliary Electricity Consumption
In Standby Mode
el
SB
0.48
0.49
W
Dimplex Optiflame Wall Fire
Models: Toluca TLC20
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the
supply voltage. Before switching on, please read the safety warnings and operating instructions.
Installation
WARNING: FALLING OR TIPPING APPLIANCES CAN CAUSE INJURY OR DEATH OF YOUNG CHILDREN,
PLEASE ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON THIS PRODUCT.
WARNING: THE APPLIANCE IS PROVIDED WITH A WALL FIXING KIT, THIS KIT IS DESIGNED TO HOLD THE
PRODUCTS WEIGHT, IT IS NOT A SUBSTITUTE FOR PROPER ADULT SUPERVISION. DO NOT ALLOW CHILDREN
TO CLIMB OR HANG ON THIS PRODUCT.
Safety Message -
Sufficient expertise is required for installing this product. If unsure we recommend that you use
an installer and pay special attention to safety during the installation.
Wall Installation- See Fig. 2
Do not connect appliance until properly fixed to the wall and the Instruction leaflet is fully read. In particular, the
minimum distances must be observed.
The wall plugs supplied with this product are for use with Block/Brick built walls only.
This model is designed to be permanently fixed to a wall at a minimum height of 300mm. The wall bracket must be
fitted horizontally and the cable routed to the bottom right of the appliance.
A height of 600 to 725mm from bottom of the appliance to floor is recommended for optimum viewing of fuel bed.
For optimum viewing, mark the top three screw fixing positions on the wall in accordance with the recommended
fixing dimensions - see Fig. 2. Drill holes with a 6mm drill bit.
Fix the wall bracket using the plugs and screws provided.Carefully lift the appliance up ensuring that the appliance
engages with the wall bracket correctly.
A bottom fixing bracket is supplied with the unit, fixed to the base of the appliance. Remove the screw and the
bracket, turn the bracket through 180 degrees so it is now facing downward and re fit using the screw just removed.
With the bracket in place mark the location of the hole on the wall. Remove the appliance,drill the wall, fit the wall
plug and re-fit the appliance ensuring that you secure it in place by screwing the bottom fixing bracket to the wall.