9
Fireplace Installation
screw location; ensure that it
is level with the first with the
help of the provided bubble
level and the fireplace itself.
Screw the threaded drywall
anchor in the drywall with a
Philip’s head screwdriver until
the head is flat against the
wall surface.
Caution should be taken
when using a power tool to
install a threaded drywall an-
chor as the drywall may dis-
tort, tear or slightly buckle as
a result of over-torque.
6. With a Philip’s head screw
driver, screw the drywall an-
chor screw into the drywall
anchor already in the wall,
leave ⅛" (3 mm) exposed
Figure 3
Heat Exhaust
threads for mounting
the fire-
place.
7. With the glass assembly tak-
en off, mount the firebox onto
the two mounting screws.
8. Mark position of hole “H”.
9. Remove fireplace from wall.
10. Install drywall anchor into dry-
wall at marked position.
11. With the glass assembly off,
mount the fireplace onto the
two mounted screws.
12. Tighten both mounting screws
with a screwdriver. Be careful
not to over tighten the screws
mated with the drywall an-
chor.
13. Secure Philip’s screw into
drywall anchor, already in the
wall (H).
14. Open the bag of pebbles and
gently pour through top open-
ing of front glass assembly.
15. Install glass assembly as
shown in Figure 4.
Built-In Instructions
WARNING:
The installation of
the fireplace unit must comply
with the applicable local and/or
national electrical codes and
utility requirements. This in-
