6
7
Specifications
Installation
Technical Information
Model No: XHD23L-EU, XHD26L-EU, XHD26L-EU-500H,
XHD28L-EU
Heat Output
230V 240V
Nominal Heat Output
P
Nom
1.3 - 1.4 kW
Minimum Heat Output
P
min
-
kW
Maximum Continous Heat Output
P
max,c
1.3 - 1.4 kW
Auxiliary Electricity Consumption
In Standby mode
el
SB
0.35 - 0.35 W
with electronic room temperature control
General
Unpack the heater carefully and retain the packaging for possible future use, in the
event of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without heating, so
that the comforting effect may be enjoyed at any time of the year. Using the flame
effect on its own only requires little electricity.
Before connecting the heater check that the supply voltage is the same as that
stated on the heater.
Please note: Used in an environment where background noise is very low, it may be
possible to hear a sound which is related to the operation of the flame effect.
This is
normal and should not be a cause for concern.
Electrical Connection
WARNING: THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the
heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating instructions.
Placement
1.
The Dimplex Electric Fireplace does
not require any special venting.
Make sure there is clearance for air
circulation beneath the unit and at
least 1/2" behind it.
CAUTION
: Do not install the fireplace
directly on carpet or similar surfaces which
may restrict air flow.
2.
Install the unit in an opening with the
following minimum dimensions:
Model XHD28
A
27" (686 mm) wide
B 31-1/8" (587 mm) high
C 8" (203 mm) deep
Model XHD26
A
24-3/8" (619 mm) wide
B 18-1/2" (470 mm) high
C 8" (203 mm) deep
Model XHD23
A
21-1/2" (548 mm) wide
B 20" (508 mm) high
C 8" (203 mm) deep
3.
If installing the unit in an existing
fireplace opening, seal all drafts and
vents with a non-fibrous insulation
material to prevent any chimney
debris from falling onto the unit. Do
not install into an existing fireplace
opening that is prone to dampness.
A
B
C
