Radiant elements
Each of the two radiant elements provides 1000 watts of heat.
A switch is set to ON when the red dot is visible.
For full heat, set both switches to ON - see
Fig. 2
.
Switch off at the wall socket to turn the heater off completely.
Unplug from the wall socket when not in use.
Maintenance
WARNING : ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Removing the guard
To remove the guard, remove the two screws along the bottom
edge of the guard, then swing the guard upwards to gain
access to the elements - see
Fig. 3
.
Replace the guard in reverse order.
Removing the elements
The element holders are spring loaded. To remove an
element, grip one end using a soft cloth to protect the surface,
then push carefully but firmly to one side until the other end
disengages from its
socket. Withdraw the element carefully -
see
Fig. 4
. Refit in reverse order.
The left-hand
switch controls
the lower element
The right-hand switch
controls the upper
element
Fig. 2
Fig. 3
Cleaning the reflector
The reflector may be more easily cleaned if the elements
are first removed (see previous). Wipe the reflector with a
warm soapy cloth, then buff with a soft dry cloth - see
Fig. 5
.
DO NOT use abrasive cleaning powders or metal polish.
Lamp replacement
Remove the fuel effect (two screws) and replace the defective
lamp with a 60
watt, 220/250 volt, 2 pin bayonet cap (BC)
fuel effect lamp. Ensure that the flicker rotor spins freely,
then reassemble.
Cleaning
Before cleaning the heater, disconnect it by pulling out the
plug from the wall socket. Do not use detergents, abrasive
cleaning powder or polish of any kind on the body of the
heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be
careful not to allow moisture into the heater.
To clean the reflector, see ‘Maintenance’.
After Sales Service
Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (excluding lamps & subject to
availability) provided it has been installed and operated in
accordance with these instructions.
Your rights under this guarantee are additional to your
statutory rights, which in turn are not affected by this
guarantee.
Should you require after sales information or assistance
with this product please go to
www.dimplex.co.uk
where
you will find our self help guide by clicking on “After Sales”
or ring our helpdesk on 0845 600 5111 (UK) or 01 842
4833 (R.O.I.) .
Spare parts are also available on the website
www.dimplex.co.uk
Please retain your receipt as proof of purchase.
Fig. 4
Fig. 5
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014,
EN60555-2 and EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
Dimplex UK Ltd.
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire. SO30 2DF
www.dimplex.co.uk
Republic of Ireland Tel.
01 8424833
[c] Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex UK Limited.
