dimtel
dimtel
5.2
Starting the EDM
5.2
Starting the EDM
Once the software has been installed and the IOCs added via
IOC add
you
are ready to start the EDM. iGp-5120F display panels are opened by the
following command:
[iGp@host ~]$ iGp_display [device name]
Note that the device name is optional. If the argument is omitted the com-
mand defaults to device name
TEST
.
5.3
Display Panels
5.3.1
Main Panel
Figure 5: Main (top-level) panel
Running
iGp display
brings up the top-level panel shown in Figure 5.
All of the display panels include two buttons on the top:
HELP
and
EXIT
.
EXIT
button will always close the current window. In addition,
EXIT
button
on the top-level panel will close the EDM session.
Top-level panel consists of three elements:
FEEDBACK ON/OFF
con-
trol,
SETUP
button and the status border around this button. The
FEED-
BACK ON/OFF
control enables or disables the FIR filter output to the DAC.
The status border indicates system operational status summary.
Green
in-
dicates no errors,
yellow
- warning (saturation),
red
- error. The
SETUP
button opens the control panel shown in Fig. 6.
17 of 58