培训手册
Training Manual
操作前检查
Pre-operation Inspection
JCPT- DCS
www.cndingli.com
3-4
倾斜表面（
Sloped surfaces
）
不牢固或光滑表面（
Unstable or slippery surfaces
）
空中障碍物和高压电线（
Overhead obstructions and high voltage conductors
）
危险场所（
Hazardous locations
）
不足以承受机器所施加全部负载力的表面支撑物（
Inadequate surface support to withstand all
load forces imposed by the machine
）
风和天气状况（
Wind and weather conditions
）
出现未经许可的人员（
The presence of unauthorized personnel
）
其它可能出现的不安全情况（
Other possible unsafe conditions
）
3.
功能测试（
Function Tests
）
功能测试用于在开始使用机器之前发现故障。操作员必须按照分步说明测试机器的所有功能。禁止
使用出现故障的机器。如果发现故障，必须标记机器并停止使用。
The function tests are designed to discover any malfunctions before the machine is put into
service.The operator must follow the step-by-step instructions to test all machine functions.
A malfunctioning machine must never be used. If malfunctions are discovered, the machine must
be tagged and removed from service.
1)
选择一个坚实、水平且没有障碍物的测试区域。（
Select a test area that is firm, level and
free of obstruction.
）
2)
确保已连接蓄电池组。（
Be sure the battery pack is connected.
）
在地面控制器上（
At the Ground Controls
）
3)
将平台和地面的红色紧急停机按钮均拉出到“开”的位置。（
Turn the red Emergency Stop
button clockwise to the on position at both the ground and platform controls.
）
4)
将钥匙开关转至地面控制器。（
Turn the key switch to ground control.
）
5)
观察平台控制器上的
LED
诊断读数装置。（
Observe the diagnostic LED readout on the ECU
window.
）
⊙
结果：
LED
应如右图所示。（
Result: The LED should look like the picture at
right.
）
测试紧急停机（
Test Emergency Stop
）
6)
将地面红色紧急停机按钮向里推至“关”的位置。（
Push in the ground red Emergency Stop
button to the off position.
）
Summary of Contents for JCPT DCS Series
