OPERATOR
’S MANUAL
with Maintenance Information
Transport and Lifting Instructions
35
Observe and Obey:
√
Common sense and planning must be
applied to control the movement of the
machine when lifting it with a crane or
forklift.
√
The transport vehicle must be parked on a
level surface.
√
The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
√
Be sure the vehicle capacity, loading
surfaces and chains or straps are sufficient
to withstand the machine weight. See the
serial label for the machine weight.
√
The machine must be on a level surface or
secured before releasing the brakes.
√
Do not drive the machine on a slope that
exceeds the slope or side slope rating. See
Driving on a Slope in the Operating
Instructions section.
√
If the slope of the transport vehicle bed
exceeds the maximum slope rating, the
machine must be loaded and unloaded
using a winch as described.
Free-wheel Configuration for
Winching
Chock the wheels to prevent the machine from
rolling.
Loosen nuts of screws provided for the
mechanical and manual release of the braking
units, and then move the nuts backwards by
approximately 8 mm.
Tighten screws so as to fasten them onto the
pressure plate.
Using a wrench, tighten the screws in an
alternate sequence by 1/4 turn at a time so as
to compress the Belleville washers and
disengage the braking disks
Summary of Contents for JCPT2223RT
Page 3: ......
Page 17: ...OPERATOR S MANUAL with Maintenance Information Decals 12 ...
