Page
11
of
20
Item – Rev(s):
9200000310 & 9200000320 – 102
5.8
Tyres and Traction
WARNING –
Dingo tyres should be filled with water and maintained at 25-30 PSI.
Failure to do so will affect the weight distribution, and can drastically reduce the stability
and carrying capacity of the machine.
A range of tyres to suit different applications, and equipment for water filling your tyres is
available to purchase from your Authorised Wacker Neuson Dingo Dealer.
5.9
Control Panel
1.
Pump selector
2.
Throttle
3.
Crowd tilt lever
4.
Drive control levers
5.
Load frame lever
6.
Flow divider control
7.
Ignition
8.
Engine warning light
9.
4in1 Bucket lever
10.
Auxiliary control
11.
Fuel gauge
12.
12V Power socket
5.10 Control Levers/ Control Panel
Ignition Switch
A keyed ignition switch is used to start and stop the engine. Check engine manufacturer’s
manual for starting instructions.
Throttle
Move the control forward to increase the engine speed and backward to decrease the
engine speed.
Drive Control Levers
To go forward, slowly push the right and left drive control levers forward. To go backward,
slowly pull the right and left drive control levers backward. To go straight, apply equal
pressure to both drive control levers.
To turn, decrease pressure on the drive control lever closest to the direction you want to
turn.
The further you move the drive control levers in either direction, the faster the machine will
move in that direction.
To slow or stop, move the drive control levers into neutral (if released the control levers will
automatically return to neutral).
The machine is capable of turning on the spot by applying equal power to each drive lever in
opposite directions.