Page
12
of
20
Item – Rev(s):
9200000310 & 9200000320 – 102
Attachment Tilt Lever
To tilt the attachment forward, slowly push the tilt lever forward.
To tilt the attachment backward, slowly pull the tilt lever backward.
Load Frame Lever
To lower the load frame, slowly push the arm lever forward.
To raise the load frame, slowly pull the arm lever backward.
Auxiliary Hydraulic Levers
The auxiliary hydraulic levers allow you to alter the direction of rotation of hydraulic driven
attachments or stop them completely.
Ensure the auxiliary hydraulic levers are in the neutral position before starting and stopping
the engine.
To operate the attachment in forward direction, slowly pull the auxiliary lever rearward.
To operate the attachment in the reverse direction, slowly push the auxiliary lever forward.
4 in 1 Bucket
The 4 in 1 bucket lever opens and closes the bucket. Push the lever forward to open the
bucket, pull the lever backward to close the bucket. When you let go of the lever it will
return to the centre position and hold the bucket in that current position.
Pump Selector
When faster ground speed and lifting speed is required more than attachment speed and
power, push the pump selector lever to the forward position.
When faster attachment speed and power is required (trenching, post hole digging etc.)
more than ground speed and lifting power, pull the pump selector lever to the rearward
position.
Flow Divider Control
In its normal operating position no flow division is taking place. Moving the lever forward
diverts oil flow to the attachment and less is available to the travel and load frame. This
allows for greater concentration of hydraulic power to the attachment.
The flow divider is mainly used for trenching, rotary hoeing and stump grinding where
greater hydraulic power is required to the attachment and less for ground speed.
Starting the Engine
Stand on the platform and move the auxiliary hydraulics lever to neutral. Follow instruction
on starting the engine as detailed in the engine manufacturer’s manual.
Stopping the Engine
Move the auxiliary hydraulics lever to neutral and the throttle to idle, and turn the key to off.
Refer to the engine manual.
