【
9-26
】
PERIODIC MAINTENANCE
○
Attach a clear plastic hose to the bleed valve on the caliper, and
run the other end of the hose into a container.
○
Bleed the brake line and the caliper as follows:
○
Hold the brake level applied [B].
○
Quickly open and close the bleed valve.
○
Release the brake lever [A].
● Repeat this operation until
no bubbles comes out the brake fluid
reservoir.
● The fluid level must be checked several times during the bleeding
operation and replenished as necessary.
● Tighten
the bleed valve to the specified torque.
Tightening Torque: 5.5 N-m (0.55 kg-m, 48 in-lb)
● Apply the brake lever forc
efully for a few seconds, and check for
fluid leakage around the fittings.
Brake Hoses
●
Check the brake hoses for leakage, cracks, wear and damage. If
any damages are found, replace the brake hoses with new ones.
A
B
NOTE
While bleeding the brake system, replenish the brake fluid in
the reservoir as necessary. Make sure that there is always some
fluid visible in the reservoir.
CAUTION
Handle brake fluid with care: the fluid reacts chemically with
paint, plastics, rubber materials, etc.
Inspect every 1000 km (50 hours, 3 months)
Summary of Contents for DL-702 2008
