【
4-34
】
SUSPENSION/STEERING/DRIVE SHAFT
Toe-Out Adjustment
●
Adjust the toe-out as follows.
●
Place the vehicle on level ground and set the handlebars straight.
●
Make sure all the tires are inflated to the standard pressure.
●
Place 75 kg (165 lbs) weight on the seat.
●
Loosen the locknuts [1], [2] on each tie rod.
●
Measure the distance ([A] and [B]) between the front wheels.
Subtract the measurement of [B] from that of [A] to find the
toe-out. If the toe-out is not within specification, adjust the tie rod
the right or left until the toe-out is within the specified range.
[B] – [A] = Tie-out
●
Temporarily tighten the four locknuts.
●
Check that the distance ([C] and [D]) are equal, as shown. If the
distances are not equal, adjust the tie rod to the right or left until
the toe-out is within specification. Check the toe-out again by
measuring distances [A] and [B].
●
If the toe-out is not within specification, repeat the adjustment as
above until the proper toe-out is obtained and distances [C] and
[D] become equal.
●
After adjustment has been made, tighten the four locknuts [1] to
the specified torque.
Tightening Torque: 27 N-m (2.7 kgf-m, 20.0 lb-ft)
NOTE
The locknuts [2] have left-hand threads.
Toe-out
Standard
10 ± 4 mm (0.39 ± 0.16 in)
1
1
2
2
B
A
C
D
Summary of Contents for DL-702 2008
