【
6-23
】
ENGINE
CLUTCH
Clutch Shoe
●
Inspect the clutch shoe for chips, cracks, uneven wear, and heat
discoloration. Also, check the depth of the grooves on the clutch
shoe.
●
If there is no groove at any part of the shoe, replace the shoe as a
set.
Clutch Wheel
●
Inspect the condition of the inner clutch wheel surface for scuffs,
scratches, cracks or uneven wear.
●
If any damages are found, replace the clutch wheel with a new one.
Starter Clutch
●
Remove the starter clutch securing bolts.
●
Install the starter clutch in the proper direction.
●
Apply the engine oil to the starter clutch.
●
Tighten the bolts to the specified torque.
Torque – Starter clutch bolts: 26 N-m
●
Install the starter driven gear to the starter clutch.
●
Check that the starter driven gear turns in the opposite direction of
the arrow mark on the rotor while holding the generator motor.
The gear never turns in the direction of the arrow.
●
If there is anything unusual, replace the one way clutch.
●
Check the starter driven gear bearing, If there is anything unusual,
replacing the bearing.
●
Remove the bearing with the special tool.
●
Install the bearing with the special tool.
NOTE
The clutch shoe must always be changed as a set.
NOTE
○
When installing the starter clutch onto the rotor, make sure the flange
side of the one way clutch faces to the rotor.
○
Face the arrow mark to the engine side.
Summary of Contents for DL702
Page 1: ... 0 0 FOREWORD INDEX ...
Page 88: ... 7 13 ELECTRICAL SYSTEM Wiring Diagram ...
Page 89: ... 7 14 ELECTRICAL SYSTEM Wiring Diagram ...
Page 90: ... 7 15 ELECTRICAL SYSTEM NOTE ...
