13
V. cleans
⑴
First according to the "pressure relief steps" to eject the pressure and coating inside
equipment.
⑵
Nozzles and nozzle jacket will be unloaded.
⑶
Add suction pipe will be put into
clear water bucket or the appropriation dilution.
⑷
Put the reflux tube into
Paint waste barrels.
⑸
Return valve will be installed in the vertical direction
⑹
Pressure control buttons will be set in the washing position
(the red area)
⑺
Turn on the power switch.
⑻
In the solvent recycling equipment, paint residues discharged until clean water or
solvent from the outflow of reflux tube.
⑼
Shut the power switch.
⑽
Return valve will be set in the horizontal position and open spray gun insurance.
⑾
turn on the power switch
⑿
Buttonning up the trigger makes
solvents
or clear water flush to remain coating inside high
pressure tube and spray gun, until
solvents
or clear water are jet from the muzzl
⒀
shut spray gun insurance.
(
as the right chart
)
⒁
Loaded nozzle jacket and open spray gun insurance.
⒂
Nozzle will be reversed 180 degrees, sustained gun deduction 1 ~ 2 seconds (cleaning
nozzles), nozzles and nozzle jacket unloaded and cleaned with brushes.(cleaning
nozzle attention to put into a white-washers and nozzles Block, please donot lost.)
⒃
Unloading equipment and spray guns on the filter net then clean
⒄
Unload suction tube filter and clean .
⒅
With piles of rags solvent or clean water equipment, high-pressure hoses and spray
gun all the components of the appearance wipe clean until a surface Adhesion without
coating.
⒆
Equipment in the infusion fluid valve 5-6 PSL drop of a closed yellow liquid.
⒇
Equipment will be stored in dry, clean and well-ventilated places