16
●
Suction ring component replacement
⑴
In accordance with the "ball valve maintenance steps"
to unload the upper and lower ball valve.
⑵
Suction component will be below the two-position
rotary nut removed.
⑶
Suction tube components will be slightly shelland pulled
down so that the shell about 1.5 cm from the equipment.
⑷
From the field in the suction components will be
introducedslowly shell straight Plunger rod to the
crankshaft andconnecting rod of the bottom of the
T-mount separation.
⑸
Will be down from the suction plunger rod components from the shell launched.
⑹
Suction components shell will be fixed on the nuts and locator removed.
⑺
Will be removed
within the shell on the three ring .
⑻
Cleaning suction components shell will be installed with new white ring back Shell.
(Installation of the order and direction of making reference to the following diagram).
Note
: new suction equipment manufactured components for the black ring ,and
suction component repair packet ring is white .
上部密封圈安装方向
下部密封圈安装方向
O
型密封圈在安装时应将上部
O
型密封圈在安装时应将下部
密封圈上的凸起面朝下
密封圈上的凸起面朝上
⑼
Carefully check plunger rod, if wear or scratches, need immediate replacement.
⑽
Will be loaded back on the ball valve and plunger rod screwed tightly .
Note
: this link can be used on the crankshaft T-type card which be screwed tightly onto
the piston rod fixation.
⑾
Will be embedded in the upper locator nut fixed, and fixed equipment to suction nut shell
components, the manpower to hand rotation.