DINO 105T
21
OPERATING THE LIFT FROM THE CHASSIS PANEL
11.
Turn the operating switch (1) to
position 3
-
now you can operate the boom with
levers 5-7 on the chassis control
panel.
-
test the operation of the emergency
descent system as follows:
-
extend the telescope (switch 7)
-
lift the boom about 1 - 2 metres
(with switch 6) and at the same time
push down the emergency stop
button (3) - the movement should
stop.
-
Open the emergency descent valve 13 for the telescope and retract the telescope completely
using the hand pump 14 (the handle is inside the main centre cover)
-
Close the emergency descent valve
for the telescope
-
Push down the emergency descent
valve 12 until the boom starts lowering
BE CAREFUL OF THE BOOM!
-
pull up the emergency stop button.
Note!
The platform levelling does not operate while the emergency descent
system is in use.
Carefully push down the emergency descent valve 12 and observe the
platform during the lowering.
DO NOT DAMAGE THE HAND BRAKE AND THE TOWBAR JOCKEY WHEEL!
From the chassis control panel the boom can only be operated at the 1-speed.
Lock the selector switch (1) in position 1 (support outriggers) before working under the boom
Make sure that neither people nor load are on the platform.
13
5
6
7
1
3
14
12
Summary of Contents for DINO 105T
