45
5. With the boom slightly lifted and the telescope extended, make sure that the platform
does not lower by itself while the operating controls are not being used.
6. Drive the platform to the work object.
DANGER
WARNING
CAUTION
NOTICE
The lift itself, the buildings around it and other obstructions constitute a risk of getting
squeezed. Hands and legs must be kept inside the work platform while the platform is
moving. Also beware of any obstacles above the platform.
IF THE SAFETY DEVICES OR THE EMERGENCY DESCENT SYSTEM ARE NOT
WORKING, HAVE THEM REPAIRED BEFORE OPERATING THE LIFT.
The platform movements can be operated with continually adjustable speed from the
platform control centre (not from the chassis control centre). Only one movement can be
operated at a time. If several control levers are operated simultaneously, only the movement
with the least resistance will operate.
Observe when lifting the platform
• the operating range of the platform depends on the load (see “Technical Data”) and is
monitored by the safety limit switches RK4 and RK5 located under the protective cover
•
The limit switches must not be adjusted or modified. The inspection and adjustment may
only be carried out by an authorized serviceman.
Working a long time in the same position
• If the weather is warm, and the platform is kept for a longer period of time in the same
position, it is not necessary to let the engine run continuously.
• if the weather is cold, keep the hydraulic oil warm by allowing the engine to run
•
ensure that the battery remains sufficiently charged even during long-term work in the
same position As necessary, use either the mains or the power pack to maintain the
sufficient state of charge of the battery.
• check the stability and condition of the base regularly during the operation, taking into
account the weather and ground conditions
• the electric timer of the lift automatically disconnects the supply voltage (12 VDC) in
about 1 hour after the electric motor or the combustion engine has been turned off.
• Re-activate the power supply by pressing the start button either in the chassis control
centre or in the platform control centre.
When moving the platform, remember the following
• beware of high voltage power lines
• do not touch open electric wires
• do not throw objects from the platform
• do not damage the lift
• do not damage other devices
Summary of Contents for DINO XT II 160
