DAG3000-112S VoIP Gateway User Manual
10
T.38 (FoIP)
Pass-Through
Modem
Adaptive
2.8.1
T. 38 and Pass-Through
T.38 is the preferred fax mode because it is more reliable and works well in most network conditions.
If the service provider supports T.38, please use this method by selecting T.38 as fax mode (default).
If the service provider does not support T.38, pass-through mode may be used. If you have problems
with sending or receiving Fax, toggle the Fax Tone Detection Mode setting.
2.9
Local IVR Operation
2.9.1
Inquire IP address
Connect analog phone to FXS ports of the DAG3000-112S gateway, then pick up the phone. After
dialing tone, dial *158# to inquire the IP address of LAN port.
2.9.2
Factory Reset
Pick up the phone, and then dial *166*000000#. After hearing a voice prompt of
‘
setting successfully
’
,
hang up the phone and the gateway is reset to factory defaults.
2.9.3
Configure LAN Port’s IP Addr
ess
Before configuration, please ensure:
The gateway is power on;
Device has been connected to network;
Telephone is connected to FXS port of the DAG3000-112S gateway.
Configure dynamic IP address by DHCP:
Pick up the phone, dial *150*2# and then hang up the phone.
If the voice prompt indicates
‘
setting successfully
’
, please restart the gateway after 10 seconds.
Configure Static IP address:
Take the configuration of IP address
‘
172.16.0.100
’
as example.
