MTG3000 VoIP Trunk Gateway User Manual
8
Copyright @ 2011-2016 Dinstar
2
Quick Installation
2.1
Preparations before Installation
2.1.1
Attentions for Installation
The attentions for installing MTG3000 include:
To guarantee MTG3000 works normally and to lengthen the service life of the device, the humidity of
the equipment room where MTG3000 is installed should be maintained at
10%-90% (non-condensing),
and temperature should be 0
℃
~ 45
℃
;
Ensure the equipment room is well-ventilated and clean;
Power supply of MTG3000 should be
100 ~ 240V AC, and its socket is a three-pin socket which should
be grounded well;
It’s suggested that personnel who has experience or who has received related training be responsible for
installing and maintaining MTG3000;
Please wear
anti-static wrist strap when installing MTG3000;
Please do not hot plug or unplug cables;
It’s advised to adopt uninterruptible power supply.
2.1.2
Preparations about Installation Site
Equipment Cabinet
Ensure the cabinet is well-ventilated and strong enough to bear the weight of MTG3000.
Trunk
Ensure telecom operator has approved to open a trunk.
IP Network
Ensure
router under IP network has been prepared, since
MTG3000 is connected to the IP network
through the standard
10/100/1000M Ethernet port.
Power Supply
Ensure the socket of MTG3000 is a three-pin socket and power supply is grounded well.
2.1.3
Installation Tools
Screwdriver
ESD wrist strap
Ethernet cables, power wires, telephone wires
Hub, telephone set, fax, and PBX
Terminal (can be a PC which is equipped with hyperterminal simulation software)
