Error! Use the Home tab to apply
标题
1 to the text that you want to appear
here.Error! Use the Home tab to apply
标题
1 to the text that you want to
appear here.
UC100-1T1S1O User Manual
Copyright©2011-2016 Dinstar
7
2.2 Installation Steps
Connect WiFi antennas to the left and right side of the gateway, and then connect the GSM
antenna to the back panel of the gateway.
LTE Antennas
WiFi Antennas
Connect the power adapter to the power jack;
Connect telephone line to the FXS port and connect PSTN line to the FXO port;
Connect network cable to the LAN port(s) and WAN port (please refer to 2.3 Network
Connection);
Insert a SIM card to the SIM slot.
2.3 Network Connection
UC100-1T1S1O works in two network modes: route mode and bridge mode. When it is under
the route mode, the IP address of WAN port must be different from the IP address of LAN
port. But when it is under the bridge mode, the IP address of WAN port and that of LAN port
are the same.
2.3.1
Network Connection Diagram under Route Mode
Under the route mode, the default IP address of WAN port is a DHCP IP address, while the
default IP address of the LAN port is a static IP address, namely 192.168.11.1.