2 Quick Installation
UC200-2S2O User Manual
Copyright©2011-2018 Dinstar
6
2
Quick Installation
2.1
Installation Attentions
To avoid unexpected accident or device damage, please read the following instructions before
installing the UC200-2S2O gateway.
The adapter of the gateway accepts DC input voltage of 12V 2A. Please ensure stable
and safe power supply;
To reduce the interference to telephone calls, please separate power cables from
telephone lines.
To guarantee stable running of the gateway, please make sure that there is enough network
bandwidth.
For better heat dissipation, please place the gateway on a flat surface and do not pile up
2.2
Installation Steps
Connect the power adapter to the power jack;
Connect telephone line to the FXS port and connect PSTN line to the FXO port;
Connect network cable to the LAN port(s) and WAN port (please refer to 2.3 Network
Connection);
2.3
Network Connection
UC200-2S2O works in two network modes: route mode and bridge mode. When it is under
the route mode, the IP address of WAN port must be different from the IP address of LAN
port. But when it is under the bridge mode, the IP address of WAN port and that of LAN port
are the same.
2.3.1
Network Connection Diagram under Route Mode
Under the route mode, the default IP address of WAN port is a DHCP IP address, while the
default IP address of the LAN port is a static IP address, namely 192.168.11.1.
