3 OF 8
IG121620-3.0
AlphaTECH
®
LED Strip Light
INSTALLATION GUIDE
AlphaTECH
®
LED STRIP LIGHT
INSTALLATION GUIDE
INDOOR/OUTDOOR INSTALLATION
Connect AlphaTECH
®
LED Strip Light, then press
firmly into channel. If necessary, include a small
amount of silicone adhesive/sealant within the
channel to hold it in place.
*Note: Placing AlphaTECH
®
LED Strip Light within another
channel may not be necessary nor recommended.
1
2
UNDERWIRE CHANNEL
Bottom Entry
H .41 in.
(10.4mm)
W .62 in.
(15.74mm)
+
−
+
−
H .62 in.
(15.74mm)
W .76 in.
(19.3mm)
W .76 in.
(19.3mm)
L 6 in.
(152.4 mm)
2.5 in. (63.5mm) 20/2 AWG Wire
2.5 in. (63.5mm) 20/2 AWG Wire
2.5 in. (63.5mm) 20/2 AWG Wire
2.5 in. (63.5mm) 20/2 AWG Wire
L 48 in.
(1219.2 mm)
End Entry
or
Bottom Entry
Bottom Entry
a
Fasten mounting clip to surface. If running wire
under channel, place AlphaTech wires in offset
(smaller) side of strain relief, and any thru-wires on
opposite (wider) side of strain relief.
Place Underwire Channels end-to-end onto
mounting clip, over strain relief, to create smooth,
linear surface.
3
Beginning of run
(6” Connection Channel)
Continue run
(48” Channels)
Run Completion
(48” Channel)
Additional connections
(6” Connection Channel)
Connector/AlphaTech wire
(place in offset)
Thru-wires
(place opposite of offset)
Mounting Clip
Strain relief
