ca.diono.com/welcome
1-866-954-9786
34
35
4. Place UAS for access to Rear-
facing belt path.
Unzip the pocket
to the right side of the latch storage
area, this will allow you to move
the latch connectors down to the
rear-facing belt path. Feed LATCH
anchors down, keeping it under the
cover and out the bottom. Once
completed, close the zip pocket.
5. Place Car Seat Rear-Facing in
Back Seat of the Vehicle
Place rear-facing in vehicle seat
and centre the car seat between
the lower UAS anchors. The base
should sit flat on the vehicle seat.
6. Locate the UAS Strap in the
Rear-Facing Belt Path.
Thread the UAS strap through the
rear-facing belt path (marked with
the blue label) and out the other
side. The UAS belt should lie flat
and not be twisted.
REAR F
A
CING
7. Attach UAS Connectors to
Vehicle’s Lower Anchors and
listen for audible click to confirm
engagement.
8. Tighten the UAS Strap
Press down firmly in the centre
of the car seat while tightening
the UAS strap. You may need to
tighten further by pulling upwards
in-line with the belt path as shown.
9. Test for Tightness
Grab the side of the seat with one
hand where the UAS strap is and
slide the car seat side-to-side and
front-to-back. If the seat moves
less than 2.5 cm (1"), it is tight
enough. Do not test by grasping
top of the seat.
10. To Remove UAS Strap From
Vehicle
Push in on the red buttons on the
UAS connects and pull them off
the anchor bars.
REAR F
A
CING
6
