8
SERVICE AND MAINTENANCE
•
Regular maintenance is required for keeping the machine safe and efficient.
•
Carefully follow the operating instructions as well as the daily maintenance
guidelines.
•
Replace worn parts, as these may increase the vibration emission.
1.
Remove the machine cover (6) and the
piston rod/tool-holder according to
the daily maintenance instruction.
2.
Slide the tool SGX-102 (11) onto the
tool-holder, see Fig. H.
3.
Squeeze the tool SGX-100 (12) and put
it inside the tool-holder. Make sure
that the tool grips the guide bushing
(13), see Fig. I.
4.
Make sure that the 2 screws are
aligned with the plastic knobs on the
tool-holder, see Fig. I.
To release the guide bushing (13) from
the outer sleeve of the tool-holder:
Tighten both screws all the way to the
bottom by means of a 2.5 mm Allen-
key.
5.
Pull the guide bushing (13) out of the
tool-holder, see Fig. J.
6.
Remove the old lubricating felt (14).
7.
Install the replacement lubricating
felt (make sure that it is drenched in
lubricating oil).
8.
Squeeze the replacement
guide bushing (13) and press it
approximately 5 mm into the tool-
holder. The knobs should be pointing
inwards and towards the machine
housing, see Fig. K.
9.
Push the bushing all the way to the
bottom of the tool-holder using the
tool SGX-101 (15), see Fig. L.
Daily maintenance
1
Do the following procedure after
every 8 hours of operation:
1.
Remove the Machine cover (6).
2.
Apply a few drops of lubrication oil to
the needle bearing in the connecting
rod, see Fig. E.
3.
Loosen (do not remove!) the screw (9).
4.
Release the piston rod/tool holder
(10) by sliding it out of the machine
housing, see Fig. F.
5.
Clean the piston rod/tool holder (10)
carefully with a soft cloth, and apply a
few drops of lubrication oil, see Fig. G.
6.
Reassemble the piston rod/tool holder
(10) into the machine housing.
1
Make sure that the piston rod goes
all the way to the bottom of the
connecting rod.
7.
Lock the piston rod with the screw (9).
8.
Reassemble the machine cover (6).
Replacement of the lubricating felt
and the plastic guide bushing
Summary of Contents for FPH/R
Page 69: ...66 ...
