Arm Assembly & Machine Head
The machine head and the arms are fairly heavy, it is suggested that the
installation is done by two persons, as instructed in the following steps.
1 Remove the screw on the protector plate and rotate the protector plate
anti-clockwise until it is vertical. Remove the hook lock after loosening the
screw.
2 Stand the machine with head facing floor and keep upright with two
hands. Another person will need to insert the tip of the arm into the
machine head.
3 Reinstall the hook lock to the grove and then tighten the groove screw
firmly.
4 Turn the protector plate clockwise back to its original position and then
tighten the screw at the protector plate either side.
5 Separately, two persons hold up the machine head and the arm assembly
at the same time. Place the arm assembly to the insert of the wall bracket.
6 Remove the stopper and fix it in an opposite way for future spare use.
Only after the installation is complete will you be able to move the arm
assembly up/down, or it will damage the arms.
7 Connect the power cable into the wall socket.
Protector Plate
Hook Lock
Stopper
Hook Lock
Grooves
Machine Head Contact Post
Machine Head
Insert of Wall Bracket
Arm Assembly
Summary of Contents for Capsule D03WM
Page 1: ...INSTRUCTION MANUAL CAPSULE D03WM H133W ...
Page 5: ......