5
DIR
www.dirgroup.co.uk
ASSEMBLY INSTRUCTIONS
The Dragon pedicure spa requires that you contact a local, licensed plumber to install your new pedicure spa.
Installation must be in compliance with all your building codes. Your pedicure spa cannot operate efficiently or
safely unless it is provided with adequate electrical power, sufficient water pressure, proper water temperature, and
required drainage capabilities. Subsequent inspections and approvals that may be required are the responsibility
of the purchaser.
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using the pedicure spa
1. Use the pedicure spa only for its intended use as described in this manual. Do not use attachments not recom-
mended by the manufacturer.
2. Never operate the pedicure spa if it has a damaged cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water.
3. Never drop or insert any object into any opening.
4. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
5. Do not block jets during whirlpool operation.
6. To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all times.
7. The pedicure spa is for indoor use only. Disconnect power supply cord before servicing and cleaning.
8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
1. Excessive water temperature is dangerous and should be checked BEFORE use.
2. Maximum temperature of the water should never exceed 100 degrees F.
3. Always enter and exit the pedicure spa slowly and carefully.
4. NEVER bring and / or operate any electrical devices into or near the pedicure spa.
Safety & Precaution
Important
Requirements
Important
Safety
Instructions
Warning
