15
© 2009 Directed Electronics. All rights reserved.
Menu 3 - Remote start
Menu
Item
Feature
Opt. 1
Opt. 2
Opt. 3
Opt.4
Opt. 5+
1
Transmission Mode
Manual*
Automatic
2
Engine Checking Mode
Virtual Tach
Voltage
Off
Tachometer
3
Cranking Time
0.6 sec.
0.8 sec.
1.0 sec.
1.2 sec.
1.4 (5)/ 1.6
(6)/ 1.8 (7)
2.0 (8)/ 4.0
(9)
4
Remote Start Runtime
12 min.
24 min.
60 min.
5
Activation Pulse Count
1
2
6
Turbo Mode
No Turbo Mode
On-1 min.
On-3 min.
On-5 min.
On- 10 min.
7
Timer Mode Runtime
12 min.
3 min.
6 min.
9 min.
8
Flex Relay Function
Ignition 2
Accessory 2
Starter 2
9
Diesel Start Delay
Wait-to Start
input
Timed 15 sec.
Timed 30 sec.
Timed 45 sec.
10
Accessory during Diesel Start
Delay
On
Off
11
Status 2 Output
Status
Latch Rear
Defogger
Pulse Rear
Defogger
12
Parking Light Output
Constant
Pulsed
Off
13
Anti-grind Output
On
Off
14
Tach Mode Starter Release
Normal
Increase
Decrease
15
Vehicle Temp Auto Report**
Off
On
16
Remote Start Safelock
Off
On
* The H1/6 Violet or the H1/8 Green wire needs to be connected for this feature.
** Not available on 1-way remote
1. Transmission Mode
Manual: requires ‘Tachometer’ for the Engine Checking Mode, and requires the user to successfully
1.
perform a procedure when parking the vehicle before remote starter will engage
Automatic: uses any of the Engine Checking Modes and does not require any special procedures
2.
when parking
2. Engine Checking Mode
VirtualTach: battery voltage drop/rise during cranking determines when the starter output is released.
1.
During runtime, constant voltage level is monitored to determine if the engine is running
Voltage: starter output during cranking is a programmed duration (Set in Cranking Time). During
2.
runtime, constant voltage level is monitored to determine if the engine is running
Off: starter output during cranking is a programmed duration (Set in Cranking Time). The remote start
3.
will keep the ignition/accessories active for the programmed runtime whether the engine is running
or not
Tachometer: tachometer input signal during cranking and runtime to determine when the starter out-
4.
put is released and if the engine is running.
3. Cranking Time
0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 seconds: determines the starter output duration during
•
cranking for the ‘Voltage’ and the ‘Off’ Engine Checking Mode options
4. Remote Start Runtime
12/24/60 minutes: sets engine runtime during normal remote start operations
•
5. Activation Pulse Count
1/ 2 pulses: sets the number of remote control commands received or Activation Input required to
•
