9
© 2011 Directed Electronics. All rights reserved.
Remote Start Shutdown/Startup Diagnostics
Shutdown diagnostics: If the remote start activates but fails to stay running, the remote start module has the
ability to inform you of what may have caused the remote start failure. Before performing shutdown diagnos-
tics it is important that you let the remote start shut off on its own i.e. let it attempt to start 3 times then shut
down, if this is not done the unit will report the shutdown you used to shut off the remote start.
Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.
To perform shutdown diagnostics:
1. With the ignition Off,
press
and
hold
the Control button (on Control Center).
2.
Turn
the ignition On and then back Off while
holding
the Control button.
3.
Release
the Control button.
4.
Press
and
release
the Control button. The status LED flashes to report the last shutdown for one minute or
until the ignition is turned on, as shown in the following table:
Status LED Flashes
Shutdown Mode
1 flash
Runtime expired
2 flashes
Over-rev shutdown
3 flashes
Low or no RPM
4 flashes
Transmitter shutdown (or optional push button)
5 flashes
(+) Brake shutdown
6 flashes
(-) Hood shutdown
7 flashes
Timer mode/Turbo mode/Manual mode error *
8 flashes
Neutral safety shutdown
9 flashes
Low battery (voltage mode)
10 flashes
Alarm triggered **
11 flashes
Wait-to-start input timed out
* Timer mode error: Ignition is on or shutdown input is active when activating timer mode.
Turbo mode error: Turbo mode is programmed off, engine is not on or shutdown input is active.
Manual mode error: MTS mode not enabled.
** Alarm was triggered during remote start sequence.
Startup Diagnostics:
If the vehicle fails to activate the remote start, the remote start module will notify you via
your Responder LC3 2-way remote control and will flash the parking lights on the vehicle to notify you of what
caused the no-start situation.
Parking Light Flashes
5 flashes
Brake wire is active
6 flashes
Hood pin wire is active
7 flashes
Manual transmission mode is enabled and not initialized.
8 flashes
Neutral safety wire has no ground or the neutral safety switch is Off.
