To enter feature programming routine
Turn the ignition ON, then OFF.
Within 5 seconds
, press and HOLD the programming button until the LED turns ON orange (after 3 seconds). Release the
Programming button.
The LED will flash green once slowly to indicate the feature number is 1. After a short delay, the LED flashes red rapidly to indicate
the current option of feature 1 (i.e. 1x green followed by 1x red indicates feature 1 is set to option 1). The flashing sequence will
repeat until a new command is entered.
Accessing another feature
Press and release the programming button a number of times to advance from the current feature to the next desired
.
The LED flashes green slowly the number of times equal to the feature number. After a short delay, the LED flashes red rapidly to
indicate the current option of the current feature.
When the maximum number of features or options is reached, the LED will start flashing again from the first feature or
option.
Once a feature is programmed
Other features can be programmed.
The feature programming can be exited.
-
-
-
-
-
-
-
Changing feature options
Press the lock/arm or unlock/disarm button on aftermarket transmitter to change the option of the selected feature.
The LED flashes red rapidly the number of times equal to the current option number. After a short delay, the LED flashes green
slowly the number of times to indicate the current feature.
-
-
The flashing sequence will repeat until a new command is entered.
feature
The flashing sequence will repeat until a new command is entered.
Exiting feature programming
-
sequence.
OR
-
Press and HOLD the programming button for 3 seconds. After 3 seconds, the LED will turn ON
for 2 seconds to confirm
.
No activity for 30 seconds; after 30 seconds, the LED will turn ON
for 2 seconds to confirm the end of the programming
orange
orange
the
end of the programming sequence
Feature Programming
Programming
Button
Page 13
Rev.: 20130304
Platform: DBALL
Firmware: GM10 v. 2.08+
© 2012 Directed. All rights reserved.
