LED
Status
Description
Troubleshooting
Module Programming
Solid Red
Waiting for Can detection.
Make sure that your HSCAN and SWCAN are properly
connected and press Unlock on the OEM remote.
Flashes Orange
CAN and Data Bypass
successfully detected.
Normal operation
Flashes Green
Cycle timeout started.
Normal operation. You have now 5 seconds to finish module
programming.
Solid Green 3 seconds
Module successfully
programmed.
Normal operation
Flashes Red 1 time
Data Bypass line sleeping or not
connected.
Press Unlock on the OEM remote to activate the Data Bypass.
Flashes Red 2 times
Failed to completely remove the
key from ignition or turned the
ignition OFF without removing the
key while bypass sequence was
executing.
Cycle (programming steps 5 to 7) was done without removing
the key. Reset module and retry module programming from
step 1.
Flashes Red 3 times
Cycle (programming steps 5 to 7)
timed out.
Cycle (programming steps 5 to 7) was done slower than 5
seconds. Reset module and retry module programming from
step 1.
Flashes Red 4 times
Data Bypass line sleeping or not
connected.
Make sure that your connections to Data Bypass are correct,
remove key, press Unlock on the OEM remote and make sure
that the LED is flashing orange before turning the key to
ignition.
Flashes Red 5 times
Programming failed.
Reset the module and retry the module programming from step
1.
Flashes Red 6 times
HS CAN not detected.
Flashes Red 7 times
SW CAN not detected.
Active Ground While Running
Flashes Green
Ground out (GWR) is active.
Normal operation
Off
Normal operation
The Ground While Running (status) wire is incorrectly
connected. Refer to the wiring diagram to make the right
connections.
Inactive Ground While Running
Flashes Green once
Lock function executed.
Flashes Green twice
Unlock function executed.
Flashes Green 3 times
Trunk release function executed.
If it does not flash, the bypass module did not receive the signal.
Verify the connections between the bypass and the remote
starter module.
Check connections and click Unlock again to activate the line.
LED Diagnostics and Troubleshooting
Flashes
Flashes
Flashes x2
Flashes x1
Flashes x4
Flashes x5
Flashes x6
Flashes x7
Flashes x3
Solid
x3 sec.
Flashes
Solid
Off
Flashes x3
Flashes x2
Flashes x1
Page 14
Rev.: 20130304
Platform: DBALL
Firmware: GM10 v. 2.08+
© 2012 Directed. All rights reserved.
