Installation Type 2
Page 7
Not required in D2D mode.
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
* Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
*** Use (-) Aux or any (-) trigger to activate the heated seats function during run time.
** If the RAP OFF wire is not connected, the radio will turn OFF but some lights will remain ON in the central console for 10 minutes. Connect this wire
(Green/Black, pin 2/12) to the driver door sense trigger (Gray/Black) to avoid the issue.
(-) Parking Lights
(AC) Tach Input*
(+) Brake Input
(-) Trunk Status Input
(-) Door Status Input
R
e
m
o
te
S
ta
rt
e
r
(-) GWR (Status)
(+) Ignition Output
(-)Trunk Output
(-) Lock Output
(-) Unlock Output
(-) Aux3***
(+) 12 V
(+) 12 V
(-) Ground
(-) Hood Status Input
1
0
DBALL
RF
Programming button
LED
1: Green: (-) Lock Input
2: Blue: (-) Unlock Input
3: Red/White: (-) Trunk Input
10: Blue/White: (-) GWR (Status) Input
6: White/Black: (-) Heated Seats
†
4
TX
(-) Ground
RX
(+)12v
1
4
1
2
2
1: Light Green: Single Wire CAN
Pin 1
Pin 6
11: Yellow/Red: Relay 2 Com
12: Brown/Red: Relay 2 NO
10: Orange/Red: Relay 2 NC
5: Violet/White: (AC) Tach Output*
6: Gray: (+) Brake Output
12: Blue/Red: (-) Hood Status Output
3: Green/White: (-) Door Status Output
4: Red/Black: (-) Trunk Status Output
2: Green/Black: RAP OFF**
11: Orange/Black: Data Bypass
10: Yellow/Black: Data Bypass
XKD2D65
(-) Ground
14: Black: (-) Ground
(-) Ground
13: Red: (+) 12v
(+) 12v
OBDII
Diagnostic Connector
Light Switch
Connector
(-) Driver Door
Sense Trigger
(Gray/Black)**
Refer to the Vehicle Wiring
Reference Chart (page 8)
for wire color and location.
6
5
4
3
2
1
Accessory, Pin 3
Ignition, Pin 1
Ignition
Control
Switch
3
2
1
Data Bypass, Pin 2
Immobilizer Control
Module (K89)
Cut
(-) Parking Lights
Refer to the Vehicle
Wiring Reference Chart
(page 8) for wire color
and location.
6
5
4
3
2
1
12
11
10
9
8
7
1: Black/White: (-) Handbrake Status Output*
(-) Neutral Safety Input/(-) Handbrake Status Input*
7: Gray/Black: (+) Accessory Output
1
8
16
9
3:Tan/Black: HSCAN High
4:Tan: HSCAN Low
Pin 14
(+) Starter Output
8: Violet: (+) Starter Input
† Heated seat feature must be enable, see
Feature Programming
(page 12).
Rev.: 20130304
Platform: DBALL
Firmware: GM10 v. 2.08+
© 2012 Directed. All rights reserved.
