P.20
User Guide
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down
after the user leaves the vehicle: the unit will take over the vehicle and keep it
running for 60 seconds (or until it is shut down by remote control), then shut
down the engine.
If your vehicle has an automatic transmission, proceed as follows to set the
system to Turbo Mode:
3. With the engine running, make sure to release the brake pedal and
press the
,
or
button on the transmitter
until the parking lights come
ON
.
4. Remove the ignition key from the ignition switch.
The engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press the
button; this will lock the doors, arm the OEM-
style alarm (if configured|) and confirm that the vehicle is in Turbo
Mode.
7. The engine will shut down after 60 seconds.
If your vehicle has a
manual transmission,
follow all steps of the
Ready
mode
routine
(page 9) to activate
Turbo
mode. At the last step, press either:
to lock the doors and have the engine shut down after 60
seconds; The parking lights will flash 3 times and remain lit.
The OEM-
style alarm and starter kill (if configured) will be armed.
to unlock the doors and have the engine shut down after 60
seconds; The parking lights will flash 3 times and remain lit.
to shut down the engine without affecting the doors.
Note:
The vehicle will enter Ready Mode once the engine run time expires.
