17
FCC Information
Battery Caution and Disposal Information
•
Improper operation of the battery (e.g., overcharging, crushing, puncture,
excessive heat or moisture) may product smoke. In such an event,
ventilate the area.
} {
or cover with sand or mud.
•
Do not disassemble, crush, puncture or incinerate.
•
Do not expose to temperatures above 140° F.
•
Do not dispose of the battery in the trash.
•
Charge fully before storage or if stored for longer than three months.
=
•
Batteries should be disposed or recycled per state and local guidelines.
To obtain warranty service, please contact Customer Support at
Toll Free Phone Number: 888-999-1675
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct theinterference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1)This device may not cause harmful interference, and (2)This device
must accept any interference received, including interference that may cause undesired
operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. such modifications could void the user's
authority to operate this equipment. Any Changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
This device is measured RF output power is less than the SAR exclusion threshold value
for human head and body . Therefore, SAR test is not necessary.
Summary of Contents for M07B7
Page 1: ...M07B7 ...
Page 3: ......
