DirekTronik 135-0810 Installation Manual Download

Page: 2 / 8

- 1 -

A. Mounting Base Installation

1. To begin the installation of the Mobotron stand, find the seat bolt in the front left

corner of the passenger seat that fasten the seat rails. Remove the left front bolt
with the correct size socket that you pre-determined.

2. Choose the mounting option that best fit your vehicle seat arrangement.

For best results try and get the stand mounting lug as vertical as possible.

3. Mounting base options: There are several options to set up your mounting base.

Please find the setup option that best fits the seat bolt and seat rail design
under the front left corner of your passenger seat.

Regular Mounting Base Setup:

If the seat bolt underneath your passenger seat is more accessible, you may
fasten the lug directly without using the brackets.

Summary of Contents for 135-0810

Page 1: ...Mobotron Universal Laptop Device Stand MS 426 MS 526 INSTALLATION MANUAL MS 426 MS 526 Best nr 135 0810 ...

Page 3: ...e choose the proper alternative mounting setup listed below Alternative I use long bracket in upper position Alternative II use long bracket in lower position Alternative III use L shape extension bracket Alternative IV use Mobotron FM 101 Universal Floor Mount Please refer to Optional Accessories section in Page 8 ...

Page 4: ...urn to the desirable position and push back the quick release lever to fix it in place 3 Loosen the bottom screw knob and adjust the angel of the bottom joint of the stand 4 For MS 526 Model Only Loosen the quick release lever on the telescoping tube Adjust the height and angle that best fits your working position After finish tighten the lever ...

Page 5: ...the angle of the upper tube When finished tighten the lever 6 Place the plastic deck on the top of the aluminum stand and then plug in and tighten the handle 7 Set your device on the deck and adjust the four sliding supports two in the front and two in the back ...