Y-
key key
*
Dual Keyboard Adapter
Installing Your
Y-
key key
Dual Keyboard Adapter
1. Check that both keyboards will operate independently on your computer through the same keyboard port:
a) Turn off the computer.
b) Plug one keyboard into the keyboard port.
c) Turn on the computer and make sure the keyboard operates properly after complete boot-up.
d) Repeat for second keyboard.
If it is not possible to get the keyboards to work independently using the same port then they will not work with the
Y-
key key.
2. After you are sure the keyboards work independently, install the adapter:
a) Turn off the computer.
b) Plug one keyboard into the port labeled "
Primary Keyboard
" on the
Y-
key key (you may need to use the
supplied five to six-pin converter). This is the keyboard the computer recognizes during boot-up.
c) Plug the other keyboard into the port labeled "
Secondary Keyboard
." NOTE: This keyboard may be
removed and the computer and primary keyboard will continue to operate.
d) Plug the
Y-
key key into the computer’s keyboard port. NOTE: The cord that should go to the keyboard
port on the computer is labeled "
Computer’s Keyboard Port
" on the
Y-
key key. The port on the computer
should be the same one you used in step 1 above.
e) With the
Y-
key key installed and both keyboards plugged in, turn on the computer, wait for complete
Tel: +46 (0) 8 52400700 Fax: +46 (0) 8 52018121
Website: http://www.direktronik.se E-mail: info@direktronik.se
