dirtdevil.com.au
6
MAINTENANCE
Emptying and cleaning the dirt container
IMPORTANT:
If the air inlet, hose or telescopic tube is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum cleaner.
IMPORTANT:
The motor is equipped with a thermal cut-out. If for any reason the unit should overheat,
the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum cleaner from
the electrical socket and turn off the switch. Remove and empty the dirt container. Check the hose for blockages.
Clean the filters. Allow the unit to cool for approximately one hour (if you have cleaned the filters you will
need to wait twenty four hours for the filters to dry before putting them back in the machine). To re-start the
machine, plug it into an electrical socket and switch it back on.
Remove dirt container by pushing
down the dirt container release
button and lifting the dirt container.
Hold the dirt container over a bin and press the dirt release latch
(located at the rear of the dirt container).
