h85(*%#(!5."5)(.#(,5
(continued)
Step 3: Remove restraining bolts (tee nut bolts) from the beam
(5.(%5--'&#-85
Use a 13mm wrench or socket to
remove the two hex bolts that are securing the beam to the
crate bottom (as shown below). Please note that the two
hex bolts are located diagonally opposed to each other.
13
Step 5:
Remove Tank & Engine Assembly from crate, then
SFNPWFUIF#FBN$ZMJOEFS"TTFNCMZ-JGU#FBN
Cylinder Assembly to its vertical position standing on the
footplate.
Step 4:
Use a 13mm wrench or socket to remove the single hex
bolt that is securing the tank assembly to the crate bottom
(as shown below).
