20
Operating Instructions
WARNING: Read and understand the complete Operation
Manual before assembling or using this product! Failure
to comprehend and comply with warnings, cautions and
instructions for assembly and operation could result in serious
injury or death.
Do not
permit children to operate this equipment at any time.
Do not
permit others that have not read and understood
the complete Operation Manual to operate this equipment.
Operation of power equipment can be dangerous. It is the sole
responsibility of the operator to understand the assembly and safe
operation of this product.
Call our customer service department at
720-287-5182,
1-877-487-8275,
or visit
www.dirtyhandtools.com
if you have
any questions or concerns about the safe operation of this
equipment.
CAUTION: Oil must be added to the hydraulic reservoir and
the engine before starting or operation.
STEP 1:
Fill the hydraulic reservoir with oil. AW32 hydraulic oil
is recommended. Automatic transmission fluid can be substituted
used instead of hydraulic oil when temperatures are below 32°F.
Use only clean oil and take care to prevent dirt from entering the
hydraulic reservoir. Fill the hydraulic tank with approximately 5
to 4 gallons of hydraulic oil. Remaining fluid is added at a later
step.
ENGINE OIL RECOMMENDATIONS
6TFTUSPLFBVUPNPUJWFEFUFSHFOUPJM4"&8JT
SFDPNNFOEFEGPSHFOFSBMVTF3FGFSUPUIF4"&7JTDPTJUZ
Grades chart in your engine owner’s manual for average
temperature ranges. The engine manufacturer recommends using
"1*4&37*$&$BUFHPSZ4&PS4'PJMɩFFOHJOFPJMDBQBDJUZJT
P[GPS,PIMFS4) 5PO5POBOEP[GPS,PIMFS
$) 5PO"MXBZTDIFDLPJMMFWFMCFGPSFTUBSUJOHUIF
engine and keep level full.
!
DANGER
!
CAUTION
