t
Reflex Duplicator Manual
- 1 -
Table of Contents
Welcome
Page 2
Before
you
start Page
2
Tutorial Guide
I. Make Disc to Disc Copies
Page 4
II. Make Hard Drive (HDD) to Disc Copies
Page 12
III. Select the Duplication Speed
Page 24
IV. Select the Master Reading Source
Page 27
V. Load Master Disc onto the Hard Drive
Page 30
VI. Rename Existing HDD Partition Name
Page 34
VII. Delete HDD Partitions
Page 37
VIII. Change HDD Partition Size
Page 39
IX. Change SETUP settings
Page 41
X. Audio CD Editing
Page 43
XI. Account Management Feature
Page 53
XII.
Duplication
Mode
Page
58
XIII. Using AUTOCOPY Feature
Page 62
Menu
Overview Page
67
1. Copy
Page 67
2. Advanced Copy Options
Page 67
3. Image
Page 67
4. Audio
Page 68
5.
SETUP
Page
68
6.
Utilities
Page
70
7.
SHUTDOWN
Page
72
Troubleshooting
Page
73
Load
Default
Settings
Page
75
t
Reflex Duplicator Manual
- 2 -
Welcome!
Thank you for buying this Disc Makers duplicator. The Reflex DVD
and CD duplicator will make it easier than ever to duplicate vast
quantities of discs. This manual contains detailed information
about using all the features in your stand-alone Reflex duplicator.
******************************************************
Before you start:
Before you start using this duplicator, please read the following to
ensure proper operation:
1. DVD Duplication Limitations:
This duplicator, it will not copy any DVD that has Copy
Protection encoded inside. DVDs you purchase or rent from a
store will be Copy Protected.
In addition to the copy protection limitation, the duplicator
will only copy a DVD-5 format (4.7GB) disc to DVD-5 format
(4.7GB) recordable DVD media. If your duplicator has double
layer capability, you can copy a DVD-9 format (8.5GB) disc to
DVD-9 format (8.5GB) recordable DVD media. You cannot
duplicate a DVD5 format disc to a DVD9 format recordable
media or vice versa.
2. Temperature Warning:
If the duplicator was stored in a location where the
temperature dropped below 32ðF (0ðC) within the past 24
hours, please leave the duplicator in a warm room with
temperatures at least 65ðF (19ðC) for 4 hours prior to
powering it on for the first time. Failure to do so may cause
irreparable harm and prevent the duplicator from functioning.
