Skip Read Error
This setting controls error skipping during source reading. The default setting is
NO. When an error is detected during the load or read in process, the duplicator
will stop the read in or load and display a READ ERROR message. If the setting is
YES, there will be no message shown even if there is an error in reading. You can use
this function to copy source CDs with errors. Press the STATUS button to change the
setting and the START button to exit.
Startup Command
This setting specifies the first function the Reflex will perform when initially
powered up. This allows the user to avoid the repeated selection of this function as the
unit is turned on. Press the STATUS button to change the setting and the START
button to exit.
Read CD DA Index 0
This setting controls the duplication of audio data existing in index 0. YES will copy the
index 0 data and NO will leave it blank. Press the STATUS button to change the setting
and the START button to exit.
Edit (ReflexPro)
The EDIT function is a track-selecting function that can combine tracks on different
CDs into one single CD. For example, you can make a collection of favorite songs from
different music CDs and record them to one compilation CD.
Switch to the CLEAR function to delete the data, if any, in the hard drive’s partition
intended to store the music tracks. Switch to EDIT by pressing the STATUS button in the
Sub Function module, load your master CD into the CD Reader (top drive). The CD
ReflexPro will analyze the master CD and show the total (XX) tracks on the LCD display
and stop at:
BEGIN TRACK
[+]
0
[QUIT]
Press the STATUS button to change the number of tracks (songs) that you wish to start
with and then press the START button to quit. After quitting, the LCD display will
stop at:
END TRACK
[+]
0
[QUIT]
The number selected must be the same or larger than that selected in BEGIN TRACK.
The same number means you want to select a single track and a larger number means
you want to select a sequence of tracks for that particular CD. After selecting the END
TRACK, the ReflexPro will bring you back to the BEGIN TRACK selection. Repeat the
same procedure to collect other tracks in different sequences that you want to duplicate.
If no more tracks will be selected, press the START button directly at BEGIN TRACK.
T
www.discmakers.com
1-888-800-4041
10
