T
www.discmakers.com
1-888-800-4041
5
Quick Start Notes for the Reflex (without hard drive):
•
Power On the system by switching the button on the lower right front
of the unit. You will then see the system initialize and perform a self
test on the front panel LED. The LED will show DETECT DRIVES
and then automatically switch to COPY < MODE.
•
To begin the duplication operation, load the top drive with the master
disc. Load the empty writer drives with high quality blank CD-R media.
The top drive is also a writer drive, which will support true maximum
speed duplication.
•
Press the START button to begin duplicating discs. The system will
automatically analyze the master disc and begin duplicating at the
maximum recording speed, depending on the writer drives maximum
write speed.
•
Upon completing the duplication process, the system will automatically
eject the duplicated discs, and the master CD.
•
To continue the same duplication job, reload the writers with blank
CD-R media, and press the START button. To start a new job, replace
the original master with a new master and follow the steps above.
•
Do not press any buttons on the Reflex during the duplication process
unless you wish to terminate the duplication session. This will interrupt
the system and ruin the CD-R media.
Quick Start Notes for the ReflexPro (with hard drive):
•
Power On the system by switching the button on the back of the unit.
You will then see the system initialize and perform a self test on the
front panel LED. The LED will show DETECT DRIVES, the capacity of
the internal hard drive, and finally COPY<MODE.
•
The ReflexPro will automatically detect the internal hard drive and
create the appropriate partitions according to its total capacity. Each
partition is 900MB.
•
Select which partition the data to be duplicated will be stored in by
selecting HDD PARTITION in the Setup Menu. The Setup Menu can be
accessed by pressing the STATUS button for five seconds and entering
the Sub Function Menu.
•
If there is no data stored in the selected partition of the hard drive, press
the STATUS button to select the LOAD function. Place the master disc
into the top CD drive. The system will automatically detect the master,
analyze, and load the data into the selected HD partition. The master
