Copy and Compare
The COPY AND COMPARE function will perform duplication and then compare the
duplicated discs with the master disc or hard drive disc image. With this function, the
discs that have been duplicated properly will be ejected and re-inserted again in the writ-
ers automatically for comparison to the original disc or hard drive disc image. The good
discs will be ejected automatically after comparison. The failed CD discs will remain in
the writers. Pressing the STATUS button will eject those failed discs.
Only data CDs can be compared with the master disc. Audio or video CDs will be VERI-
FIED (self-reading) instead of being compared with the master even if COPY AND COM-
PARE is selected.
Emulate
The EMULATE function performs the same operation as COPY except that the
data is not actually written onto the CD-R media. CD-R discs will remain blank when the
emulation operation is performed. This operation is used to confirm the status of the tar-
get master disc, or the hard drive disc image. It is also used to test the system during
setup or after being transported.
Compare
The COMPARE function performs comparison between master and target discs (data
CDs only).
Verify
The VERIFY function performs verification of audio or video data written to blank
CD-R media from a target or master disc. Different discs in the CD writer and CD
reader can be verified together simultaneously.
Load
Use the LOAD function to load master data into the hard drive before performing
other functions.
Place the master CD disc into the top reader drive or any one of the CD writers,
ReflexPro will automatically detect and analyze the master CD and load its data into the
current partition of the hard drive.
The hard drive installed in the ReflexPro will be automatically partitioned by
900MB in each partition. Number of partitions available depends on the hard drive’s
capacity. No pre-formatting or software setup is required to install the hard drive. Each
partition in the hard drive will be labeled in alphabetical order. Partition numbers can be
selected under HDD PARTITION in the Setup menu.
The ReflexPro will prompt you with an error message when you try to duplicate from a
partition that contains no data. Switch to a proper partition or use the LOAD function to
load the master data into the current partition.
T
www.discmakers.com
1-888-800-4041
7
