16
Loader Processing
Drive 2 <- Input Bin
Input Bin Empty(20)
Continue?
PASS 100 FAIL 0
Job Completed! Press OK to Finish
ReflexAuto B.30
1. Copy (MM)
ReflexAuto B.30
8. Master Mode (SM)
Once the duplication run is completed, the loader will remove the finished
disc from the drive and place the successful copy on the Output Spindle and
if there are any bad/NG copy to the reject area.
The loader will then pick up another blank disc and load it into the drive. This is then repeated for each disc.
The copying process will continue until you either run out of blank discs or
until the count that you loaded into the counter is reached.
If you run out of blank discs and the job is not complete, the autoloader will give you an opportunity to fill the
spindle:
Important: When you add discs to the input spindle, be sure to remove your finished discs from the
Output Spindle.
At this point you can either put more discs on to the input spindle and press
the Enter button to continue, or press the ESC button to terminate your
project.
Once the autoloader is through, you will see the following screen:
PASS 100" indicates that you made 100 successful copies.
FAIL 0" indicates that you have no failures for this job.
At the bottom of the screen, you will see the scrolling message: Job Complete! Press OK to Finish
1.2 Making Copies in Multi Master Mode
This mode does not require you to manually load your master. Simply place the master disc(s) on top of the
stack of blank discs needed for that particular job of the master disc. This mode is ideal if you have
numerous master discs and fewer copies for each master disc.
The Multi Master mode uses the Reserve partition to temporarily store the content of the current master disc.
Once the task is complete and a new master disc has been detected, the reserve partition's content (of the
previous master disc) will be replaced with the content of the new master disc.
For more information on Multi Master Mode, see Single Master and Multi Master Modes on page 10.
Turn on your autoloader and wait until it has booted up. It should take several minutes for the autoloader to
go through its self adaptive test and auto-calibration procedures. You should see the following signifying
your autoloader is ready:
Make sure the Master Mode is set to Multi Master mode (MM). If it is not,
use the Up or Down button to navigate to the 8. Master Mode screen. If it is
already in Multi Master mode (MM), please skip to the step that starts the
copy process.
Press the Enter button to enter the Master Mode Menu and you will see a
screen similar to one of the following:
Loader Processing
Drive 1 -> Output Bin
