User Guide 1.0
8
www.discmakers.com/techsupport
3. Button Beep (Menu Function 6.3)
n
This option will allow the user to turn on or off the audio signal when a button is pressed.
Press the UP and DOWN buttons to switch between ON and OFF. Press ENT to
select and exit.
[Button Beep]
ON
5. Ignore Size (Menu Function 6.5)
n
This function is to set the tolerance in percentage of capacity difference between
source and target cards / drives. To ensure the FAT table of each drive is duplicated
correctly, the duplicator will require the source and all target cards/ drive to be identical
in capacity. However, it is inevitable for each drive, although marked the same capacity,
to be slightly different due to the manufacturing process. Therefore, a tolerance may
be set to avoid a system error. For example, if the source drive has a capacity of 1919MB,
with a 3% tolerance setting any target drive with a capacity of 1976MB to1861MB will be
accepted. Setting to a higher tolerance percentage will allow source flash copy to targets
with different capacity’s, such as copying a 1GB source device to 2GB target device(s).
The default is set to “Don’t care,” which means the size difference is ignored and there is
no limit of source and target capacity difference.
4. Asyn Hold time (Menu Function 6.4)
n
This option allows the user to set the time the system waits when all writer trays are
unloaded before exiting the asynchronous mode. The default is set to 30 seconds.
n
When the system is in asynchronous mode, it executes the copy or compare function for
each writer tray individually. After all target drives are removed, the system will wait
for the set amount of time for any new drive to be inserted to continue the job. If no
more drives are inserted after the hold time, the LCD will prompt:
Press ENT to exit this Asynchronous or press ESC to keep this status.
Wait too long
Exit?
n
If a source device has a smaller capacity than target devices:
1. Set the tolerance % to “Don’t care”. There will be no limit on source and target
capacity difference.
2. After the copy process is completed, the target devices will be formatted to the same
capacity as source device.
t
Reflex
Flash
