3. Press the
Up
or
Down
arrow to change the track in view. To select a track to
copy to the blank disc press the
ENT
key, a + will appear next to the track in
view. In the following example track 3 is in view and is selected for copying.
More than one track can be chosen from a CD but they will be recorded to
the destination in the order in which they are on the original CD. To change
the order of play, copy each track individually.
4. After selecting a track (or tracks) to copy press the
Up
arrow until
End
appears. In this example one track is selected and the time for this track is
2:41.
If four tracks were selected the screen would show
4 Trk
and give the total
time for all four tracks.
5. Load the other recorders—one or as many as needed—with
Disc Makers
Ultra CD-Rs
.
6. Press the
ENT
button and the ReflexMax will ask if all the selections are
made for this CD. Use the
Up
or
Down
arrow to change between
Yes
and
No
.
Pressing
ENT
with
No
on the LCD will take the user back to
Select Track
.
Pressing
ENT
with
Yes
on the screen will start the copying of the track (or
tracks) to the target blank CD.
7. When the copying ends the unit will display
Burn Complete! OK: 01
.
Press the
ENT
button. The LCD will display
Continue edit next Disc? NO
.
To change to another CD, Load the top recorder drive
Src
with another mas-
ter disc, press the up arrow to change the
No
to
Yes
and press
ENT
. This will
take you to the screen from
Step 3
. Repeat steps 3 through 6 to add more
tracks on the compilation.
8. When there are no more tracks to write to the compilation leave the
Continue
edit next Disc? NO
set to
No
and press the
ENT
key again. The following
screen will appear:
Press
ENT
and the ReflexMax will close the CD. Once the CD is closed, no
additional tracks can be copied to the CD.
The LCD will display
Close Complete OK: ... Fail: ...
the number of discs
closed successfully will be next to
OK
and they will be ejected, any failures
will remain in the recorder drives.
The ReflexMax can compile to the hard drive as well, in
Step 2
use the
Down
arrow to to select
10-02. Edit Track CD to hard drive Edit
and press
ENT
.
Steps 3 and 4
will be the same to select the tracks to copy. It is not neces-
sary to load any media.
Step 6
will load the selected track(s) to the hard
drive. The last few steps will proceed as follows:
7. When the copying ends the unit will display
Image load OK
, pressing
ENT
will
display
Continue edit next Disc? NO
Leaving this set to
No
and pressing
ENT
the screen will display
Burn or Move to partition? Burn
. Use the down arrow
to change the
Burn
to
Move
then press
ENT
.
Select Partition A
will be dis-
played. Use the down arrow to select a partition to copy to and press
ENT
.
You will see
Moving to P: ...
and then
OK!
to confirm the writing to the hard
1-888-800-4041
www.discmakers.com
T
11
Funct
io
n
s
Select Track:
+3/31
3:18
TRACK IN VIEW
TOTAL TRACKS ON DISC
TIME OF TRACK
1
Select Track:
End
1 Trk 2:41
End edit disc
and burn?
YES
Close all discs
session?
YES
