load the recorder drives with high quality blank CD-R media. Press the
ENT
button to start the process. The unit will analyze the master on the
Src
drive,
and then any disc in the recorder drives.The LCD will display the number of
discs that passed the test and then proceed directly to the copy process.
Upon doing a successful
Test and Copy
the following will display on the LCD.
In this example, two discs were successfully tested and copied.
If the target blank CD-R has already been written to, or is damaged and can-
not be written to, the drive for this disc will not open. Likewise, if the data on
the master CD will not fit on the blank target CD, the drive will remain closed.
4. V
ERIFY
The
Verify
function is used to confirm that the master and the copy read the
same. Again this function operates similarly in both the
Hard-Drive-to-Disc
and the
Disc-to-Disc
mode
1. Select the
Verify
function using the
Up and Down
arrows.
2. In the
Hard-Drive-to-Disc
mode: load the drives with the copied discs. The
unit will analyze the master on the hard drive, and then compare that to any
disc loaded in the recorder drives. The LCD will display the number of discs
that verified correctly and the number that failed the verification. Those that
verified correctly will be ejected from the recorders. All failures will remain in
the drives.
3. In the
Disc-to-Disc
mode: Load the top drive
Src
with the master disc and
load the recorder drives with the previously written media. Press the
ENT
button to start the process. The unit will analyze the master in the
Src
drive,
and then any disc in the recorder drives.The LCD will display the number of
discs that verified and the number that failed. Those that verified correctly
will be ejected from the recorders. All failures will remain in the drives.
In the example above, three discs verified correctly and one disc failed the
verification.
The
F->
indicates that by pressing the
ENT
button the failed disc(s) will be
ejected from the recorders. Please be careful to remove the correctly verified
disc(s) before pressing
ENT
again.
To verify more duplicated discs, simply fill the recorders and press
ENT
,
again.
5. C
OMPARE
The
Compare
function takes the
Verify
function one step farther, it gives
details about the master and copied disc. It also ejects the disc upon a suc-
cessful comparison.
1. Select the
Compare
function using the
Up and Down
arrows.
2. In the
Hard-Drive-to-Disc
mode: load the drives with the copied discs. The
unit will analyze the master on the hard drive, and then compare that to any
disc loaded in the recorder drives. The LCD will display the number of discs
that compared correctly and the number that failed. Those that passed the
comparison will be ejected from the recorders. All failures will remain in the
drives.
3. In the
Disc-to-Disc
mode: Load the top drive
Src
with the master disc and
load the recorder drives with the previously written media. Press the
ENT
button to start the process. The unit will analyze the master on the
Src
drive,
and then any disc in the recorder drives. The LCD will display the number of
discs that compared correctly and the number that failed. Those that passed
the comparison will be ejected from the recorders. All failures will remain in
the drives.
08
Funct
oi
n
s
1-800-237-6666
www.discmakers.com
T
3. Test and Copy
OK: 02
4. Verify
F->
OK: 03
Fail: 01
