IPTV Encoder
Page 3
DiscoverVideo IPTV Encoder
Installation
Connect desired Audio/Video input, 100/1000 Ethernet, and Power. Power is supplied
by an external AC power supply and connects via a locking DC connector. The 19-
inch shelf is powered by internal power supply and only requires AC power.
Video input is HDMI with or without embedded audio. Audio input may also be
analog via 3.5 mm jack and optional RCA connector adapter (female).
Ethernet is standard 100/1000 supporting IP V4.
Find IP Address
Apply power and allow a few minutes for the encoder to boot up.
Each encoder is shipped configured for DHCP and will get an IP address
automatically.
To find the IP address used install and run the DiscoverVideo IP Finder program on a
Windows computer.
If you do not or cannot use DHCP, reset the encoder by inserting paper clip or similar
into
the reset hole above the mark “RST” in the front panel and hold the reset button
down for 15 seconds.
Be sure to push the paper clip in straight to avoid touching anything other than the
target button.
This will factory reset the encoder and it will then have DHCP IP address. You may
then configure your computer to use this same network to access the encoder web
user interface and set the IP address as desired. Please note that DHCP will not set
the DNS address and this must always be set manually if DNS is required.
Chapter 2:
Configuration
