10
4. On the UHF Pro remote control that came with the kit, press
and hold the
SAT
mode button for three seconds until all
mode buttons light. Then, let go.
5. Use the
NUMBER PAD
buttons to enter the number you wrote in
step 3.
6. Press the
POUND
(
#
) button.
If you entered the address
correctly, the
SAT
mode button will flash three times.
U
SING
THE
R
EMOTE
C
ONTROL
After you have installed the converter and set up your UHF Pro remote
control, make sure that the remote can control your receiver in the
same room and also from other places where you want to use the
remote control. If the remote cannot control the receiver, see
Troubleshooting the Kit
on page 42.
R
EMOTE
C
ONTROL
O
PERATION
This section describes how to use the remote control that came with the
kit.
C
HANGING
THE
R
ECEIVER
AND
R
EMOTE
C
ONTROL
A
DDRESSES
1. Open the
System Information
screen. Consult your receiver user's
guide for instructions on how to open this screen without using the
remote control. The
System Information
screen will show either
one
Remote Address
, or it may show a
Primary Remote Address
and a
Secondary Remote Address
.
Note
: On the DISH Player-DVR 522 and DISH 322, program the
remote control on TV1 only.
2. Press and hold the
SAT
mode button about three seconds,
until all the mode buttons light up, and then let go of the
SAT
button. The
SAT
mode button will blink.
3. Use the
NUMBER PAD
buttons to enter any number from
1
to
16
.
The
SAT
mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered: __________
Note
: If using more than one UHF Pro remote control in your
house, make sure that the remote controls are set to different
addresses from each other.
4. Press the
POUND
(
#
) button. If you entered the address
correctly, the
SAT
mode button will flash three times.
Pyramid.book Page 10 Wednesday, February 16, 2005 4:00 PM
